Pick it MC2
Entry-level moving-coil phono cartridge with an elliptical diamond stylus on an aluminium cantilever, aimed at owners of entry to mid-level turntables who want to move from MM to MC. It has a low 0.4 mV output, so a good phono stage is recommended.
- Moving-coil cartridge, 0.4 mV output at 1 kHz
- Elliptical diamond on aluminium cantilever
- Neodymium N40H magnet, square coil, 6N OFC windings
- Tracking force 1.7–2.1 g, 1.9 g recommended
- Threaded body, half-inch mounting, no nuts needed
- Needs a phono stage with MC input and enough gain
Foto
5Annunci
Ancora nessun annuncio di questo modello
Quando qualcuno venderà un Pick it MC2, qui compariranno gli annunci e lo storico delle vendite.
Vendine uno ugualeDescrizione
The Pick it MC2 is a moving-coil cartridge that replaces the Pick it MC1 as the entry point to the maker's MC range. It pairs an elliptical diamond with an aluminium cantilever, and the light stylus and coil assembly is meant to give wider frequency range, better transient response and more resolution of low-level detail than comparable MM designs.
The generator uses a neodymium N40H magnet and a square coil wound with 6N OFC copper. The body is resonance-optimised ABS, and the whole cartridge weighs about 5 g. Its medium compliance suits most entry-level to mid-range turntables and tonearms. Tracking force is 1.7–2.1 g, with 1.9 g recommended.
It mounts in a standard half-inch pattern, and threaded holes in the body allow fitting without nuts. Because MC output is roughly 20 dB lower than MM, it needs a phono stage with enough gain and a suitable MC input. The low source impedance reduces hum pickup, and the design suits balanced connections.
Specifiche
- Marca
- Pro-Ject
- Modello
- Pick it MC2
- Categoria
- Attrezzatura DJ › Testine e puntine
Cartridge
- Cartridge principle
- MC (Moving-Coil)
- Stylus type
- Elliptical on alu cantilever
- Magnet
- Neodymium N40H
- Generator coil
- Square
- Windings
- 6N OFC pure copper
- Body material
- Resonance optimized ABS
Audio
- Output voltage at 1 kHz
- 0,4 mV (3,54 cm/sec)
- Channel separation at 1 kHz
- >27 dB
- Frequency response
- 20 - 20 000 Hz +/- 1dB
- Tracking ability at 315Hz
- 70 μm
- Dynamic compliance
- 15 μm/mN
- Recommended load resistance
- 50-200 Ω
Setup
- Tracking force, range
- 1,7 - 2,1 g (mN)
- Tracking force, recommended
- 1,9 g (mN)
- Height stylus tip to top mounting surface
- 17 mm
- Tracking angle
- 22°
- Mounting standard
- 1/2 inch, threaded holes
Physical
- Cartridge weight
- 5 g