TLM 127
Large-diaphragm FET studio condenser microphone with switchable omnidirectional and cardioid patterns, plus remote selection of five patterns through a dedicated power supply. Aimed at home studio users and audio professionals who need a flexible vocal and instrument microphone.
- Large-diaphragm FET condenser, transformerless design
- Omni and cardioid on the mic; five patterns via N 248 remote
- Self-noise 8 dB(A), max SPL 140 dB (154 dB with pad)
- 14 dB pad and high-pass filter at 15 Hz or 100 Hz
- 48 V phantom powered, XLR 3 output
- EA 1 elastic suspension included, wooden box
Foto
8Annunci
Ancora nessun annuncio di questo modello
Quando qualcuno venderà un TLM 127, qui compariranno gli annunci e lo storico delle vendite.
Vendine uno ugualeDescrizione
The TLM 127 is a transformerless large-diaphragm condenser microphone built around the K 127 capsule, which is derived from the K 103 used in the TLM 103. Its sound character comes from the capsule alone, with no electronic equalisation. It is addressed from the side, and a three-position switch on the front selects omnidirectional, cardioid or remote control ("R").
On the back are a 14 dB pre-attenuation switch and a two-position high-pass filter: 15 Hz ("LIN", 12 dB/octave) or 100 Hz, which can be used to reduce proximity effect. Self-noise is 8 dB(A), maximum SPL is 140 dB (154 dB with the pad engaged), and the A-weighted dynamic range is 132 dB.
The microphone runs from standard 48 V phantom power over a 3-pin XLR connection. With the optional N 248 power supply and the switch set to "R", wide-angle cardioid, hypercardioid and figure-8 become available by remote control over cable runs of up to 300 m. The internal assembly and capsule are elastically mounted, and an EA 1 elastic suspension is included.
Video
Specifiche
- Marca
- Neumann
- Modello
- TLM 127
- Categoria
- Studio › Microfoni
Audio
- Acoustical operating principle
- Pressure gradient transducer
- Directional pattern
- Omnidirectional, cardioid (wide angle cardioid, hypercardioid and figure-8 also available via remote control)
- Frequency range
- 20 Hz ... 20 kHz
- Sensitivity at 1 kHz into 1 kohm
- 12 mV/Pa
- Equivalent noise level, CCIR
- 20 dB
- Equivalent noise level, A-weighted
- 8 dB-A
- Signal-to-noise ratio, CCIR (re. 94 dB SPL)
- 74 dB
- Signal-to-noise ratio, A-weighted (re. 94 dB SPL)
- 86 dB
- Maximum SPL for THD 0.5%
- 140 dB
- Maximum SPL for THD 0.5% with preattenuation
- 154 dB
- Dynamic range (A-weighted)
- 132 dB
Controls
- Pattern switch
- Omnidirectional, cardioid, remote control (R)
- Pre-attenuation
- 14 dB
- High-pass filter
- 15 Hz (LIN, 12 dB/octave) or 100 Hz
Outputs
- Matching connector
- XLR 3 F
- Rated impedance
- 50 Ohms
- Rated load impedance
- 1000 Ohms
- Maximum output voltage
- 10 dBu
Power
- Supply voltage (P48, IEC 61938)
- 48 V ± 4 V
- Current consumption (P48, IEC 61938)
- 3.2 mA
- Maximum cable length (remote control)
- 300 m
Physical
- Diameter
- 57 mm
- Length
- 173 mm
- Weight
- 450 g
In the box
- Included
- Microphone, EA 1 elastic suspension, wooden box